Type II Drop Plates

Drop Plates fit between the spring plate and the bearing housing to create a drop of 75mm to give clearance between the chassis

and the control arm. Matched with Adjustable Rear Spring Plates it allows a drop further than 100mm in the rear while allowing removal

and replacement of the rear wheels.

Drop Plates MUST be used with adjustable spring plates as it drops the rear of the bus just a little too far to remove the rear

wheel without the aid of the Adjustable Spring Plates.

Once installed, the rear ride height is only governed by the clearance between the chassis and the suspension. 

Buy the on Ebay for a short time free postage.

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=220610818414&ssPageName=STRK:MESELX:IT